SMR Gearbox Set up
Satisfactory overall performance relies on good set up. lubrication and upkeep. thus it is vital that the directions during the set up and upkeep leaflet. supplied with every gearbox. are followed thoroughly. several of the essential facets of belt and torque-arm installation are listed under.
1. Install pulley on gearbox input shaft as near on the reducer attainable, and mount reducer on driven shaft as near to bearing as sensible. failure to try and do this can cause extra loads in the input shaft bearings and output bearings and could cause their premature failure.
2. Install motor and wedge belt drive using the belt pull at around 90° on the center line between driven and input shafts. this will permit tensioning with the wedge belt drive using the torque arm which should really preferably be in stress. if output hub runs anti-clockwise. torque arm need to be positioned the proper.
3. lnstall torque-arm fulcrum on a rigid help to ensure the torque-arm might be at about ideal angles for the center line through the driven shaft along with the torque arm case bolt. ensure that there’s enough get up from the turnbuckle for belt stress adjustment.
Keep shut.
Bell drive might be found in any effortless postion. if your torque arm is to be made use of to tighten the belts, the drive really should be at about tight angle to your line in between the input and output shafts.
Bell drive may very well be found for the proper if sought after.
If output hub rotates clock-wise. position belt 
drive and torque arm in opposite route to that proven inside the illustration.
Torque arm and belt get up.
Torque arm could possibly be mounted for the right if sought after.
