The 14 sizes of typical roller chains are available ranging from 25 to 240 including those in conformity with ANSI (American Nationwide Regular Institute), and ISO (International Organization for Standardization).
The chains not merely meet the requirements to the minimal tensile power prescribed by ANSI and ISO, nevertheless they also deliver the top class good quality while in the planet together with a substantial fatigue strength
Ideal uses
?Common use for driving and lifting products.
Examples
?Driving transfer units 
together with other tools. For multilevel parking.
Selection of chains
For choice of a chain, see the tables of “Max. Horsepower Ratings” for regular roller chains and “Designing of Chain Transmission”. Nevertheless, only to get a special situation of low pace and significantly less shock, “Low-speed selection” process can also be referred to.
Regular roller chains up to five strands can be found. The conventional system for connecting pins and plates is rivet sort (RP).
The cotter type (CP) is available for common chains and HK chains of 80 or larger.
Sprockets
The regular roller chains could be engaged with typical sprockets of the corresponding nominal numbers. For sprockets, refer towards the table of “Dimensions” for each dimension of chain.
Connecting hyperlinks and offset back links
For connecting back links and offset hyperlinks, refer to your table of “Dimensions” for each size of chain.
The connecting links are normally R or C connecting links by which the pins are Fashion “MD” ELEVATOR BUCKETS for basic objective elevators clearance-fitted with the connecting plate. Considering that clearance-fitted hyperlinks are inferior to your base chain in Max. allowable tension as from the situation of one-pitch offset backlinks (OJ), “Low-speed selection” can’t be referred to. Since the Max. kilowatt ratings are determined looking at the power of connecting back links and OJ, the clearance-fitted connecting links and OJ can be applied if your chains are chosen in accordance to your “General selection”. When a increased Max. allowable tension is needed to the connecting hyperlink, utilize the interference-fitted connecting link (H connecting link) of a HI-PWR-S chain, and during the case of offset links, use 2POJ.
