1.A connecting hyperlink of an O-ring Chain for general application is pre-coated with grease on the pins. Before connection, verify the grease over the surfaces of pins, and in the event the volume of grease is little, apply grease with bare hands. (If gloves are used, the grease will likely be absorbed by the gloves.)
Instance: When the connecting hyperlink (I) of an O-ring chain for basic application is
shipped, O-rings are fitted in the roots with the pins. If the O-rings come loose because of vibration in the course of transport, refit the O-rings in for the roots with the pins.
In this case, be sure to return the grease collected on the roots on the pins towards the central surfaces in the pins, additional at portion A than at portions B proven from the above illustration. (Portions A is worn due to sliding with the bushings.)
2.The chain may be most easily connected around the teeth of the sprocket. Engage the links at both ends in the chain with the sprocket teeth and fit connecting pins. If the sprocket might be moved, the chain can also be linked to the loosened side.
3. Connecting procedure
one.Confirm that O-rings are attached for the roots on the pins.
2.When the amount of grease applied about the connecting pins is smaller, coat the pins with grease with the central portions.
three.Insert the connecting pins to the bushings in the inner back links at both ends.
four.Confirm that the grease is applied for the whole encounter on the O-ring, and match the O-ring onto the connecting pins.
five.Insert the connecting pins to the connecting plate and while pressing the connecting plate, install the spring clip. Confirm no matter if the head (the finish with no split) in the spring clip is turned in the feeding route of your chain. (See the next illustration.)
six.Be sure to confirm that the spring clip is securely fitted while in the clip grooves on the connecting pins.
This completes jointing on the connecting hyperlink. Note that grease about the surfaces of connecting pins and O-rings may be removed throughout set up perform. In this case, re-grease making use of the grease about the surface on the base chain or the grease during the polyethylene bag by which the connecting link was contained.